Stamp Images

Stamp Images

a standard frustration i hear from rubber stampers at a category is "i messed up - my stamped image is crooked." a very simple repair for this problem is to use the stamp-a-ma-jig, a tool for stamping an image within the precise position you need to have.

the stamp-a-ma-jig has 2 pieces - the t-shaped positioning instrument and a transparent, plastic, sq. sheet. The t-shaped instrument has a non-skid backside. The vertical line is lengthyer that the horizontal one.

the process is easy. First you stamp the image on the plastic sheet. then you definately place the sheet over your venture, say a card or scrapbook web page, in order that the picture is considered the situation you need the final stamp to be. Then stamp the image on that individual spot. Here are the main levels.

place the clear, plastic square in your work floor. Slide over the positioning tool, in order that one of the nooks made via the t is butted up once morest probably the most high corners of the plastic sheet. I'm proper-handed, so i situation the tool at the top left corner of the plastic sheet. A left-handed stamper would place it at the top right nook. Ink the stamp and hold it above the sheet, proper within the nook of the t. carefully slide the stamp straight down, and stamp the image on the sheet. It doesn't matter how darkish the picture is, so long as you will discover it.

lay the plastic sheet on the project you're making. Transfer it so that the image is strictly over the place you are having a look to have the ultimate place of the stamped image stamped. As before, slide over the placeing software, in order that it is butted up against the nook of the clear sheet. If the sheet transfers, then begin this step over once extra. It's essential to position the placeing instrument, without disturbing the plastic sheet. Now, carefully get rid of the sheet, with out transferring the positioning instrument. The software should be over a section of the outside to be stamped, grasping it in place. only as you did prior to on the clear sheet, stamp the image, with the assist of sliding the stamp down alongside the nook of the placeing instrument. the result would be the picture stamped in the precise position you want to have!

there are some extra tricks that may will let you.

if your stamp is brief and wide, as ceaselessly greetings are, then you may also prefer to lay the placeing instrument horizontally in a nook of the plastic sheet. this provides extra contact between the stamp base - either timber or acrylic - and the positioning tool while you're stamping.

if you're seeking to stamp on a very small piece of paper or card inventory, you can also run into an issue. while you transfer the plastic sheet away, the positioning tool is additionally too a long way to carry the paper in position. If this occurs, then glue the paper to your work floor with a transient adhesive. Get the t-shaped positioning instrument in situation, as all the time. While you cast offd the plastic sheet, the tool won't be grasping down the paper or card stock. On the other hand, the temporary adhesive will hold it lengthy enough so that you simply can finish the procedure. Your ultimate stamped image might be perfectly placeed! simply decide it up and glue to your mission, as needed.